Canton Roof Pros provides professional flat and low-slope roofing in Canton, OH for residential and commercial properties across Stark County. Almost every low-slope roof we touch in Canton is a piece of a steep roof house. The rear kitchen ell, the porch, the second-floor sleeping porch that got enclosed in the fifties, the flat-topped bay. Each one drains into the same cornice trough as the main roof.
That connection is the whole job. A membrane that stops at the edge of its own deck and hands water to a built-in gutter through an unflashed joint will leak at that joint regardless of how good the membrane is. We run the membrane down into the trough and bond it to the lining, or we run one continuous liner through both, so there is no seam where the two systems meet.
For material we mostly use fully adhered EPDM on residential ells and porches, because it takes movement, it patches cleanly twenty years later, and a Canton porch roof does not need reflectivity. Where a low-slope section sits against a taller wall and gets sun, we use a granulated modified bitumen cap over a mechanically attached base. Ballasted systems are wrong for a residential porch and we do not offer them.
Slope gets built, not assumed. Anything we call flat we want draining at a quarter inch per foot toward a real outlet, which on these additions usually means tapered insulation or furring the deck, since the original framing was laid dead level and has since sagged toward the middle. We shoot the deck with a level before ordering anything, because a sag of an inch over twelve feet changes the taper layout completely.
The wall termination is the other failure point. A membrane turned up a brick or clapboard wall and caulked at the top will let go within five years. We terminate into a reglet cut into the mortar joint, or under counterflashing tucked behind the siding, with a bar and sealant behind the metal rather than smeared in front of it. Sealant goes behind the metal, never in a bead across the front of it.
Repairs to existing low-slope work start with a probe survey and, on anything larger than a porch, a core cut, because there is no point resurfacing a deck with saturated insulation under it. If the core comes up wet we will show you the plug and quote a tear-off instead. A core cut takes ten minutes and settles an argument that otherwise runs for weeks.
Our licensed and insured team brings the right materials and equipment to every job — soldered twenty-ounce copper box-gutter lining, fully adhered single-ply liner over a rebuilt gutter floor, cornice bed board carrying the trough beneath the rafter tails, scarfed rafter-tail sisters cut back to sound wood, penetrating epoxy consolidant on checked cornice stock, lock-seam conductor and cast collar at the trough outlet — and backs the work with a written workmanship warranty. We serve Canton and nearby communities including Massillon, North Canton, Alliance, Louisville.
What We Handle
Everything our flat and low-slope roofing in Canton covers
One crew, one point of contact, and the full range of flat and low-slope roofing work in Canton, OH. If it is on this list we do it in house rather than handing it to a subcontractor:
- flat roof repair canton oh
- low slope roofing canton ohio
- epdm roof canton
- tpo roof installation stark county
- porch roof replacement canton
- modified bitumen roof canton oh
- rear addition flat roof canton
- flat roof leak repair canton ohio
- rubber roof canton oh
- low slope membrane canton
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Canton services.
Materials, equipment and how we do flat and low-slope roofing
The difference between flat and low-slope roofing that lasts and flat and low-slope roofing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with soldered twenty-ounce copper box-gutter lining, fully adhered single-ply liner over a rebuilt gutter floor, cornice bed board carrying the trough beneath the rafter tails, scarfed rafter-tail sisters cut back to sound wood, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Canton job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in Stark County means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do flat and low-slope roofing outside Canton
Canton Roof Pros covers Canton and the surrounding communities of Stark County. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Flat and Low-Slope Roofing in Massillon, OH — Stark County, population 32,146
- Flat and Low-Slope Roofing in North Canton, OH — Stark County, population 17,842
- Flat and Low-Slope Roofing in Alliance, OH — Stark County, population 21,672
- Flat and Low-Slope Roofing in Louisville, OH — Stark County, population 9,521
- Flat and Low-Slope Roofing in Canal Fulton, OH — Stark County, population 5,325
- Flat and Low-Slope Roofing in Hartville, OH — Stark County, population 3,329
Start on the Canton Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Canton Chooses Canton Roof Pros
- ✓We price the roof edge before the roof field, because on Canton's pre-war stock the built-in gutter is what decides the job
- ✓Every proposal quotes relining the trough and removing it side by side, with the maintenance cost of each stated
- ✓We will not hang seamless gutters under a live box gutter and call it a repair, and we will explain on site why that fix fails
- ✓We refuse to trowel roof cement or fibered coating into a wooden gutter, because sealing the top surface only makes the floor rot faster
The standards behind flat and low-slope roofing
Quality here is not a matter of opinion — it is written down. The flat and low-slope roofing work we do in Canton follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every flat and low-slope roofing project in Canton gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free flat and low-slope roofing free estimate in Canton, or request a quote and we'll get right back to you.